First, inspect engine. Then, find leak. After that, repair hose. Finally, test system., First, check tire. Then, find pressure. After that, inflate wheel. Finally, verify result., First, examine brake. Then, identify wear. After that, replace pad. Finally, test brake., First, inspect wire. Then, locate damage. After that, change cable. Finally, check circuit., First, check battery. Then, see voltage. After that, charge unit. Finally, measure power., First, examine filter. Then, notice dirt. After that, remove part. Finally, install new filter., First, inspect light. Then, identify fault. After that, replace bulb. Finally, verify operation., First, check panel. Then, notice screw. After that, tighten fastener. Finally, inspect area., First, examine valve. Then, find blockage. After that, clean component. Finally, check flow., First, inspect fuel line. Then, detect leakage. After that, seal connection. Finally, verify safety., First, check sensor. Then, see error. After that, replace device. Finally, test reading., First, examine oil tank. Then, find low level. After that, add lubricant. Finally, measure quantity., First, inspect landing gear. Then, locate loose bolt. After that, tighten fitting. Finally, check movement., First, check hydraulic pump. Then, notice vibration. After that, change equipment. Finally, test pressure., First, examine seal. Then, identify crack. After that, install gasket. Finally, verify joint., First, inspect antenna. Then, detect damage. After that, repair connection. Finally, test signal., First, check microphone. Then, hear noise. After that, replace equipment. Finally, verify communication., First, examine oxygen mask. Then, notice defect. After that, change mask. Finally, inspect equipment., First, inspect structure. Then, locate crack. After that, repair section. Finally, verify work., First, check cockpit display. Then, see error message. After that, reset screen. Finally, test function., First, examine control cable. Then, find slack. After that, adjust tension. Finally, check movement., First, inspect reservoir. Then, see low fluid. After that, add liquid. Finally, verify level., First, check connector. Then, notice corrosion. After that, clean contact. Finally, test connection., First, examine aircraft door. Then, find damaged seal. After that, install replacement. Finally, check closure., First, inspect aircraft. Then, identify fault. After that, correct problem. Finally, complete test.

TECHNICAL PROBLEM

por
Imprimir
Incrustar

Tabla de clasificación

Estilo visual

Opciones

Cambiar plantilla

¿Restaurar actividad almacenada automáticamente: ?