Q1. What is the main purpose of health and safety procedures in a barbershop?, . To make the shop look professional, . To prevent accidents, injuries and ill health, . To reduce the number of clients, Q2. Who is responsible for maintaining health and safety in the workplace?, . Everyone in the workplace, . Only the barber, . Only the manager, Why must barbers follow workplace health and safety procedures?, . To protect themselves, colleagues and clients, . To finish work earlier, . To avoid cleaning, What should you do first if a client has an accident?, Make the situation safe and provide appropriate assistance, Ask them to leave, Carry on with the service, What is a hazard?, Someone who works in a barbershop, Something that could cause harm, A workplace rule, Which of the following is a control measure?, Leaving a cable across the floor, Cleaning up a spill, Using faulty equipment, What can poor posture cause over time?, Musculoskeletal problems, Better concentration, Stronger hair, What is dermatitis?, A type of haircut, A hair growth cycle, Inflammation or irritation of the skin, Which of these is an employee responsibility?, Ignoring health and safety, Using unsafe equipment, Following workplace procedures, Which is an employee right?, The right to a safe working environment, The right to ignore workplace rules, The right to ignore clients, What is the outer layer of the hair called?, Cortex, Medulla, Cuticle, Where does hair growth take place?, Hair follicle, Cuticle, Hair shaft, What is the main purpose of shampoo, To permanently straighten the hair, To remove dirt, oil and product build-up, To cut the hair, What can happen to the skin after very close clippering or shaving?, It may become irritated, Hair will permanently stop growing, It will always become stronger, What is the purpose of a heat protectant?, To permanently colour the hair, To protect the hair from heat damage, To increase scalp oil

Barbering Knowledge

tekijä
Tulosta
Upota

Tulostaulu

Visuaalinen tyyli

Vaihtoehdot

Vaihda mallia

Säilytetäänkö automaattisesti tallennettu tehtävä ?