Void setup - This section of code initially runs once when the program is run, and is used to tell Arduino what to expect its input/output pins to be doing or connected to., Commands - Are an instruction given in a program that tells the computer to do something specific. The main ones we will work with are keywords., Semicolon ; - To tell Arduino it is at the end of that line of code., Void loop - This section of code runs over and over until the power is switched off or the program has an ending statement., Curly braces { } - These begin and end sections of code and Arduino needs them to recognise “paragraph structure” in your program., Comments - Are put into the program to remind the programmer or tell someone else looking at the program what is happening in that line or section of code. They are not compiled or ‘read’ by the compiler., Serial monitor - To allow you to see what the program is doing “in the background” even if your circuit doesn’t appear to be working. Serial monitor is a good way to check your code is correct/working.,

Programming Codes Part 1

על ידי
הדפסה
הטבעה

לוח תוצאות מובילות

סגנון חזותי

אפשרויות

החלף תבנית

האם לשחזר את הנתונים שנשמרו באופן אוטומטי: ?