1. Use the ____ and pipette filler to add 25 cm3 of alkali to a clean ____. 2. Add a few drops of ____ e.g. ____ and put the conical flask on a ____ The solution should be ____. 3. Fill the ____ with ____ and note the starting volume. 4. Slowly add the acid from the burette to the alkali in the conical flask, ____ to mix. 5. Stop adding the acid when the ____ is reached (the appropriate colour change in the indicator happens). Note the final volume reading. The ____ between the reading at the start and the final reading gives the volume of acid (or alkali) added. This volume is called the ____. 6. The first titration is a ____ titration and gives an idea of the ____ of acid needed. 7. ____ the procedure but this time when you approach the end point (about 3-5 cm3 less than the rough titration), add the acid ____ until the solution turns ____. The same method works for adding an alkali to an acid – just swap around the liquids that go into the conical flask and burette.

Titration

על ידי
הדפסה
הטבעה

לוח תוצאות מובילות

סגנון חזותי

אפשרויות

החלף תבנית

האם לשחזר את הנתונים שנשמרו באופן אוטומטי: ?