Place MDF mould in the base of the Vacuum Former - Step 1, Place sheet of plastic above the mould and clamp securely - Step 2, Pull heater hood over plastic and turn the heater on - Step 3, Plastic becomes flexible - Step 4, Push back heater hood - Step 5, Pull handle down to raise mould upwards - Step 6, Flick the vacuum switch - air will be pumped out of the area below the plastic and mould - Step 7, Turn vacuum off - Step 8, Lift handle back up, so mould lowers - Step 9, Unclamp plastic - Step 10, Cut out - Step 11,

Classifica

Stile di visualizzazione

Opzioni

Cambia modello

Ripristinare il titolo salvato automaticamente: ?