1. What is the usual centre-line radius of a copper bend?, Four times the pipe diameter, Twice the pipe diameter, The same as the pipe diameter, Ten times the pipe diameter, Which part of the bend should always be marked?, Throat, Heel, Centre, Outside edge, When using a bending machine, where should the fixed measured point face?, Away from the operator, Towards the operator, Towards the floor, Towards the former, What phrase helps a plumber remember the correct bending position?, Waste to waist, Heel to steel, Pipe to right, Mark and pull, Why should a spring bend be slightly over-pulled?, To make the spring easier to remove, To reduce the pipe diameter, To increase the pipe wall thickness, To harden the copper, Which bend allows one pipe to cross another?, Passover, Back-to-back bend, Single 90-degree bend, Centre bend, What is one advantage of bending pipe instead of using fittings?, Reduced frictional resistance, More joints are required, More solder is required, Installation takes more space, Which rule should be followed before cutting or bending?, Measure twice, cut or bend once, Mark once and cut twice, Bend first and measure afterwards, Always work from the open end
0%
Copper bending
共有
共有
Tonywalters
さんの投稿です
KS3
コンテンツの編集
セーブ
いいね!
印刷
埋め込み
もっと見る
ログインが必要です
表示スタイル
すべてを表示
フォント
アクティビティ設定
リーダーボード
割り当て
サブスクリプションが必要です
アクティビティ設定
リーダーボード
このリーダーボードは現在非公開です。公開するには
共有
をクリックしてください。
このリーダーボードは、リソースの所有者によって無効にされています。
このリーダーボードは、あなたのオプションがリソースオーナーと異なるため、無効になっています。
オプションを元に戻す
もっと表示する
表示を少なくする
クイズ
は自由形式のテンプレートです。リーダーボード用のスコアは生成されません。
割り当て
まだ課題を設定していません。
結果の収集を開始するには、任意のアクティビティページに移動し、[
課題の設定
]を選択します
設定を確認し、結果のリンクを生徒と共有します。
課題を設定
テンプレートを切り替える
すべてを表示
オープン結果
リンクをコピー
QRコード
削除
自動保存:
を復元しますか?