1) You are repairing a computer that has a damaged hard drive. Upon opening the laptop, you realize that the screws securing the hard drive have a star-like shape. What tool should you use? a) Flat Head Screwdriver b) Philips Head Screwdriver c) Torx Screwdriver d) Hex Driver 2) You are about to start a computer repair and have an anti-static mat available. However, you realize that it is not connected to a grounding point. What should you do? a) Start the repair immediately, as the mat alone is sufficient. b) Ground yourself by touching a metal object and then proceed without connecting the mat. c) Connect the anti-static mat to a grounding point before beginning the repair. d) Use the mat for storage only and work directly on the table. 3) You are working on a delicate electronics project that involves assembling tiny components on a circuit board. You need to pick up a small resistor that is difficult to grasp with your fingers. What type of hand tool should you use? a) Tweezers b) Part Retriever c) Flashlight  d) Wire Cutter 4) You are tasked with cleaning the interior of a computer to remove dust and debris from sensitive components. You have a can of compressed air available. Which of the following actions should you take to ensure safe and effective cleaning? a) Hold the can upside down to increase the pressure while spraying. b) Spray the compressed air in short bursts while keeping the nozzle a few inches away from the components. c) Use the compressed air continuously for several minutes to ensure all dust is removed. d) Shake the can vigorously before use to mix the contents for better airflow. 5) What is the main purpose of using a multimeter to test computer components? a) To measure the voltage, current, and resistance of electrical circuits b) To check if the computer is turned on and working properly c) To clean the internal components of the computer d) To install new software on the computer 6) Selecting the best tool for each task requires training in the proper use of the tools, field experience in their safe use, and following the manufacturer's guidance and instructions for that specific tool. a) TRUE b) FALSE 7) When obtaining the tool, all the associated tooling and consumable parts, as recommended by the manufacturer, must be included.  a) TRUE b) FALSE 8) The safe use of a tool depends on using the tool for the purpose for which it was designed and also for other purposes where it can be used as substitute where tool is not available. a) TRUE b) FALSE 9) All tools should be kept in good condition with regular maintenance. a) TRUE b) FALSE 10) Preparing for a task includes only knowing the task to be done. a) TRUE b) FALSE

TOOLS IN COMPUTER HARDWARE SERVICING

인쇄
퍼가기

순위표

비주얼 스타일

옵션

템플릿 전환하기

자동 저장된 게임을 복구할까요?