Lathe, A machine tool used to shape metal or wood by rotating the workpiece against a cutting tool., Milling machine, A machine that removes material from a workpiece using a rotating cutting tool., Grinding machine, A machine that uses an abrasive wheel to smooth or shape surfaces., Machine bed, The base or foundation of a machine tool that supports all main components., Frame / Base, The structure that gives stability and alignment to the machine., Clamping system, A mechanism that holds the workpiece in position during machining., Chuck, A clamping device that holds the workpiece on a lathe., Machine table, A flat surface that supports the workpiece on milling or grinding machines., Main switch, A switch that turns the machine on or off., Emergency stop, A safety device that immediately cuts off power to stop the machine., Slideways, Guides that allow controlled linear movement of parts in the machine., Gear unit, The mechanical system that transmits motion and power within the machine., Control unit, The part of a machine used to operate and adjust speed, feed, and other settings., Motor, The component that provides power to drive gears and control units., Headstock, The part of a lathe that holds the spindle and transmits rotation to the workpiece., Spindle, A rotating shaft that holds or drives a cutting tool or workpiece., Speed selection lever, A lever used to set the rotation speed of the spindle., Feed, The controlled movement of the cutting tool or workpiece during machining., Saddle, A part of a lathe that supports and moves the cross slide and toolpost., Toolpost, The part that holds the cutting tool on a lathe..

Reading

etter
Skriv ut
Innebygd

Poengtavle

Se toppspillere

Ledertavle

Visuell stil

Alternativer

Bytt mal

Poengtavle

Se toppspillere
)
Gjenopprett automatisk lagring: ?