1. What is the usual centre-line radius of a copper bend?, Four times the pipe diameter, Twice the pipe diameter, The same as the pipe diameter, Ten times the pipe diameter, Which part of the bend should always be marked?, Throat, Heel, Centre, Outside edge, When using a bending machine, where should the fixed measured point face?, Away from the operator, Towards the operator, Towards the floor, Towards the former, What phrase helps a plumber remember the correct bending position?, Waste to waist, Heel to steel, Pipe to right, Mark and pull, Why should a spring bend be slightly over-pulled?, To make the spring easier to remove, To reduce the pipe diameter, To increase the pipe wall thickness, To harden the copper, Which bend allows one pipe to cross another?, Passover, Back-to-back bend, Single 90-degree bend, Centre bend, What is one advantage of bending pipe instead of using fittings?, Reduced frictional resistance, More joints are required, More solder is required, Installation takes more space, Which rule should be followed before cutting or bending?, Measure twice, cut or bend once, Mark once and cut twice, Bend first and measure afterwards, Always work from the open end
0%
Copper bending
共享
共享
由
Tonywalters
KS3
编辑内容
保存
喜欢
打印
嵌入
更多
需要登录
视觉风格
显示所有
字体
活动设置
排行榜
作业
需要订阅
活动设置
排行榜
此排行榜当前是私人享有。单击
,共享
使其公开。
资源所有者已禁用此排行榜。
此排行榜被禁用,因为您的选择与资源所有者不同。
还原选项
显示更多
显示更少
随堂测验
是一个开放式模板。它不会为排行榜生成分数。
作业
您尚未与学生分享任何活动。
要开始收集结果,请转到任何活动页面,然后选择
Set assignment(设置分配
)。
确认您的设置并与学生共享生成的链接。
设置作业
切换模板
显示所有
打开成绩
复制链接
QR 代码
删除
恢复自动保存:
?