1) The pictured component can be identified as:- a) A starter solenoid b) An inertia starter motor c) A pre-engaged starter motor d) A starter motor armature 2) The component highlighted by the green arrow in the image can be identified as the:- a) Commutator b) Slip ring c) Rotor d) Brush box 3) The pictured component can be identified as the starter motor:-  a) Rotor b) Armature c) Commutator d) Stator 4) An advantage of the pictured starter motor is that:- a) Pinion is constantly engaged with the flywheel ring gear b) A starter circuit 4-pin relay does not need to be used c) The pinion engages with the ring gear before torque is applied d) The pinion starts to rotate at speed before it is engages with the ring gear 5) Which component within the pictured starter motor prevents the pinion from being driven by the flywheel once the engine has started? a) Armature b) Commutator c) Over-run clutch d) Gear train 6) The purpose of the gears within the pictured starter motor is:- a) Increase the torque at the pinion b) Reduce the torque at the pinion c) Increase the speed of the pinion d) Reduce the speed of the armature 7) Current draw of a starter motor is best measured using:- a) An amp clamp b) A DMM c) A voltmeter d) a Multimeter  8) An inhibitor switch on a starter motor circuit for an automatic car is most likely to be found on the:- a) Starter motor  b) Gearbox c) Clutch pedal d) Engine 9) The component highlighted by the red arrow in the image can be identified as the:- a) Stator b) Commutator c) Field winding d) Brush box 10) Which one of the following will 'not' contribute to a starter motor turning slowly? a) 4-pin starter relay b) 12 volt car battery in a poor state of charge c) Partially seized engine d) Defective starter motor 11) With which component does the pictured starter motor pinion engage with? a) Clutch pressure plate b) Crankshaft c) Flywheel ring gear d) Gearbox gear train 12) The item highlighted by the blue arrow in the image can be identified as the starter motor:-  a) Brush kit b) Bearing c) Rectifier d) Field winding 13) The pictured instrument panel light indicates:- a) The vehicle is fitted with auto stop start technology b) The vehicle is fitted with automatic transmission c) Auto stop start technology is not currently available d) Starter current (Amps) draw high 14) The function of a starter motor is to:- a) Convert electrical energy into mechanical energy b) Convert mechanical energy into electrical energy c) Convert Kinetic energy into mechanical energy d) Convert electrical energy into heat energy 15) What reference number on a wiring diagram is used to identify cranking feed/ supply a) 15 b) 50 c) 30 d) 31

Starter Components & Circuits

打印
嵌入

排行榜

视觉风格

选项

切换模板

恢复自动保存：？