In vehicle suspension - What is the meaning of dive?, The lifting of the front of the vehicle under acceleration , The dipping of the rear vehicle when braking , The dipping of the front of the vehicle when braking, The lifting of the rear under acceleration, "Oversteer" Is Produced During Cornering When, Slip Angles on the rear tyres are greater than the front, Rear Wheels of the car are carrying less load than the front, Slip Angles are the same on both the front and rear, Slip Angles on the front tyres are greater than the rear, Which Of The Following Faults Could Be Caused From Worn Shock Absorbers, Poor Vehicle Acceleration, A Decrease In Braking Distance, An Increase In Braking Distance, Reduced Road Spring Oscillation, A Driver Is Experiencing Shaking From The Steering Wheel Which Gets Worse At Higher Speeds. Whats the Likley Fault, Shock Absorbers Need Replacing, Tyre Pressure Is Too High, Front Wheels Need Balancing, Wheel Alignment Needs Adjusting, What Can Air In The Hydraulic Braking System Cause?, Increased Wear On Brake Pads And Discs, A Weak/Spongy Brake Pedal, Corrosion Of The Brake Lines And Pistons, Brake Fluid To Boil Under Prolonged Braking, What Fault Will Change Camber Angle?, High Tyre Pressures, Unbalanced front wheels, Incorrect Toe Settings, Buckled Front Wheel, An Advantage Of Alloy Wheels To Steel Is, Are cheap to manufacture, Decreases Unsprung Weight, Increases Unsprung Weight, Reduce heat transfer, what is IFS, independent forced suspension, independent front struts, independent front suspension, independent forward struts, The aspect ratio of a tyre is measured in:, A percentage, Inches, Millimeters, A ratio, what does Hygroscopic mean, Attracts flies, Absorbs brake fluid, Absorbs Moisture, Attracts dirt, The diameter of the wheel shown on the tyre is normally measured in:, millimetres, feet, Centimeters, inches, What does the positive camber mean?, The top of the wheel tilts outward, The front of the wheel is facing outward, The top of the wheel tilts inward, The strut is mounted diagonally, What is Ackerman steering?, High speed stability, Power assisted, Toe out on turns, Self centering action, Front wheel drive cars generally have this toe angle when stationary., Toe in, Toe out, Zero toe, One wheel toe in and the other toe out, Rear wheel drive cars generally have this toe angle when stationary., Toe out, Toe in, Zero toe, One wheel toe in and the other toe out, What provides self aligning steering?, Camber, Caster, Toe in , toe out, what is the minimum legal thickness of brake pads?, 1.6 millimetres , 2 millimeters , 1.5 millimetres , 5 millimeters , In relation to checking and adjusting the front wheel alignment which of these is NOT true?, You should remove any very heavy loads from the boot, You should check the tyre pressures are correct, Buckled wheels will not affect the wheel alignment, Adjustments must be made equally to both track rods, What is the nominal section width of a tyre with the following markings 195/55/16 87W?, 55 mm, 87, 16 inches, 195 mm, Why is ABS fitted to vehicles?, to stop the brakes from overheating , to brake quicker under all conditions, to stop shorter under all conditions, to prevent wheel lock when braking, 205 60 R 15 85 H '15' represents?, Width, Aspect ratio, Circumference, Rim diameter, What component is being indicated by X in the diagram?, The Tyre Bead, The Retaining Ring, The Bracing Belt, The Detachable Flange, A suspension damper dampens the spring oscillations by, converting kinetic energy into heat energy, converting heat energy into kinetic energy, converting generic energy into heat energy, converting chemical energy into heat energy, Excessive toe-out of the front wheels will cause:, wear on the outside shoulders and feathering of the tread, wear on the inside shoulders and feathering of the tread, excessive over steer when travelling at speed, intermittent bald spots on the front tyres, An advantage of power assisted steering over manual steering on heavy vehicles is that:, it reduces manufacturing costs, it has less moving parts, it requires less maintenance, it reduces driver fatigue, Over inflated tyres will be worn , on both edges of the tread, Inner edge, outer edge, feathered , centre portion of the tread, The centre point of the steering is defined where, Centre lines of the wheel kingpin intersect at ground level, Lines at 90 degrees to the wheels intersect at the centre of the corner, Centre lines of wheel and steering arms intersect at ground level, Centre lines of the steering arms intersect at rear axle, What is the purpose of a swinging shackle fitted to a leaf spring?, To resist axle movement under acceleration , To allow for sideways movement of the spring when cornering , To provide different spring rates depending on loads, To allow for changing lengths of the spring during movement, A ball joint is?, Located at the centre link, supports linear free play, A connection that allows for movement in every direction, Bolted to the suspension damper, Cords of a radial ply tyre, cross at 135 degrees to the bead, Cross at 45 degrees to the bead, Cross at 90 degrees to the bead, cross at 180 degrees to the bead.

IMI LV04

аутор
Одштампај
Угради

Табела

Визуелни стил

Поставке

Промени шаблон

Врати аутоматски сачувано: ?