CONTINUED, The type of dimensioning method in which dimensions are placed sequentially end-to-end is ___., CYLINDRICITY, The tolerance that controls the overall geometric form of a cylinder is ___., BREAK, What dimensioning view is shown in the image?, REPEATED, Dimensions should not be ___ to avoid conflicting instructions., AXIS, A datum is defined as a virtual ideal plane, line, point, or ___., CIRCUMFERENCE, The radial dimension can be placed internally or externally relative to the ___., ANGULARITY, What geometric tolerance symbol is shown in the image?, FLATNESS, A surface that must remain uniformly level without tightening other dimensions uses ___ tolerance., CAM, Arc length dimension is typically used for measuring travel distance around a ___., ALIGNED, A dimension created parallel to two specified points is ___..
0%
TYPE-C
Podeli
Podeli
Podeli
autor
Rajapremium7
Uredi sadržaj
Odštampaj
Ugradi
Više
Zadatke
Tabela
Prikaži više
Prikaži manje
Ova tabela je trenutno privatna. Kliknite na
Podeli
da biste je objavili.
Pristup tabeli je onemogućio vlasnik sredstva.
Ova tabela je onemogućena pošto Vam se podešavanja razlikuju od podešavanja vlasnika sredstva.
Vrati podešavanja
Ukrštenica
je otvoreni šablon. On ne generiše rezultate za tabelu rangiranja.
Prijava je obavezna
Vizuelni stil
Fontove
Potrebna je pretplata
Postavke
Promeni šablon
Prikaži sve
Više formata će se pojaviti tokom igranja aktivnosti.
)
Otvoreni rezultati
Kopiraj vezu
QR kôd
Izbriši
Vrati automatski sačuvano:
?
