Which type of drawing shows floor plans, elevations, sections and detailed brickwork?, Site diary, Risk assessment, Bill of quantities, Working drawings, Which document specifies brick type, mortar, DPC and joint finishes?, Work schedule, Manufacturer’s brochure, Specification, Method statement, Which information source lists all materials needed including quantities?, Bill of quantities, Risk assessment, Specification, Floor plan, Which drawing best shows wall thickness, structural components and DPC positioning?, Location plan, Section drawing, Gantt chart, Elevation, What is the main purpose of a materials schedule?, Show boundaries, Determine labour costs, List materials, Record incidents, What is typically shown using hatchings on a drawing?, Labour requirements, Mortar ratios, Scaffolding layout, Material symbols, Which brick type is commonly used above DPC for weather resistance?, Engineering brick, Common brick, Concrete block, Handmade brick, How many bricks per m² are expected in a one‑brick‑thick solid wall?, 100, 120, 60, 80, What percentage is typically added for materials wastage?, 20%, 15%, 2%, 5%, Coping stones are normally calculated using which type of measurement?, Linear, Diagonal, Area, Volume, Which component is used to provide a rigid alternative to flexible DPC in garden walls?, PVC strip, Engineering brick courses, Polythene sheet, Damp membrane, Tile creasing is normally calculated using which two factors?, Wall length & tile colour, Tile thickness & joint size, Tile width & wall length, Mortar type & wall height, Which term refers to estimating materials by laying bricks dry to check bond?, Pier setting, Bond striking, Gauge checking, Dry bonding, What is a key factor when selecting the correct mortar ratio?, Cost of sand, Brick strength, Colour of bricks, Delivery weather, Which ratio includes lime for softer facing bricks?, 4:1:1, 6:1, 3:1, 5:1, Protecting materials with polythene sheets helps prevent:, Wind uplift, Ground movement, Weather damage, Brick expansion, Which tool is used to transfer angled cuts accurately?, Lump hammer, Bolster, Sliding bevel, Brick trowel, Before cutting any brick, what should always be done first?, Dry lay course, Measure size, Apply mortar, Add water, Which factor must always be considered when storing materials on site?, Weather & run-off, Daily temperature, Office location, Foreman vehicle, Which document provides instructions on how to safely carry out a task?, Programme of works, Bill of quantities, Schedule, Method statement

Unit 204 Solid walling L.O1 v2

by
Print
Embed

Leaderboard

Visual style

Options

AI Enhanced: This activity contains content generated by AI. Learn more.

Switch template

Continue editing: ?