The controller showed a much lower voltage than we expected., The engineer saw an unusual increase in the battery temperature during the test., Why did the inverter show a different power output yesterday?, We lost communication with the battery for about ten minutes yesterday., The monitoring system gives us detailed information about energy production and consumption., What reading did you get from the second controller?, The two controllers gave different values, so we checked the system again., We found the cause of the communication problem after checking the network settings., The customer told us that the inverter stopped sending data during the night., The engineer didn’t find any problems with the DC voltage during commissioning., The inverter went into standby mode when the battery level became too low., Why did the battery stop charging when the state of charge reached only 70%?, The monitoring platform sent us a warning about an unusually high battery temperature., We had a similar problem with this inverter last month., The engineer chose the wrong parameter and had to configure the inverter again., The inverter is showing an unusually high DC voltage, so we should check the readings before restarting it., You mustn’t change the battery parameters without checking the manufacturer’s specifications first., Yesterday, we had to restart the controller because it stopped sending data to the monitoring platform., You have to disconnect the inverter before carrying out this type of maintenance., The engineer couldn’t access the inverter remotely because the customer’s internet connection was down., The values on both controllers are identical, so we don’t have to compare them again., This controller can display voltage, current, power output, battery status, and system alarms., During commissioning, we had to adjust several parameters because the default settings were not suitable for this battery., The battery temperature is within the normal range, so we don’t have to shut down the whole system., Before changing this setting, you have to make sure that the new value is within the recommended range., Why do we have to reset the controller if all the readings are normal?, The inverter was operating normally, but suddenly we couldn’t see any data from it on the monitoring platform., The controller can show how much power the solar panels are producing and how much energy the system is consuming., We didn’t have to replace the controller because a firmware update solved the problem., The two controllers are showing different state-of-charge values, so we need to find out which reading is correct.

complete the sentences

by
Print
Embed

Leaderboard

Visual style

Options

AI Enhanced: This activity contains content generated by AI. Learn more.

Switch template

Continue editing: ?