What architectural change in Falcon 8X EASy III increases ASCB data throughput compared with the EASy II implementation?, ARINC 429 is replaced by analog synchro buses, Manchester encoding is replaced by more efficient 8b10b encoding, RS-422 is replaced by MIL-STD-1553 encoding, When assessing this system behaviour, which answer is consistent with the aircraft training data? With the AP not connected before entering a speed-protection zone, which protection is NOT added by the AFCS?, PFCS configuration adaptation and pitch protection, Aural alerts and speed-tape cues, Automatic autothrottle engagement and AP pitch commands, Which Flight Director mode inhibits autothrottle operation according to the ATA 22 logic?, Windshear mode, Heading Select mode, Altitude Hold mode, During a post-maintenance system review, which statement correctly explains the condition below? Under which condition is the autothrottle automatically engaged as part of speed protection?, Whenever the FD is on, regardless of AP status, At speed-protection activation when the autopilot is engaged, Only after the pilot manually moves all throttles to idle, A technician must verify the correct component or system response. Which option is correct? Which statement about manual autothrottle engagement is correct?, It is possible with the AT pushbutton on the Guidance Panel for any thrust-director mode, It is allowed only in climb and cruise modes, It requires both TOGA buttons to be held for more than two seconds, For fault-isolation purposes, which of the following statements is correct for this situation? How are the sidestick AP DISCONNECT switches electrically arranged?, Normally closed in series, opening when pressed, Normally open in parallel, grounding their output when pressed, Normally open in series, supplying 28 VDC when pressed, During a functional review, which answer best matches the system behaviour described below? What is the role of the secondary Flight Director system while the primary FD system is controlling the aircraft?, It is powered off to prevent conflicting commands, It operates as a hot spare and can automatically become primary, It controls only the autothrottle speed reference, Which statement correctly addresses this condition? What is true if the autopilot is engaged when no lateral or vertical Flight Director mode is selected?, The AP cannot engage without both FD axes active, The AP can engage even without a lateral or vertical FD mode engaged, The AP immediately disconnects and generates AFCS: AP FAIL, While troubleshooting the aircraft, which response correctly applies to the following ATA system scenario? Which combination correctly describes FD mode concurrency?, Two lateral and two vertical modes may be engaged simultaneously, Only one lateral and one vertical mode may be engaged, with one of each also able to be armed, Only one total FD mode may be either engaged or armed, Which option is technically correct? How is the Flight Director master/high-priority channel selected during normal AFCS operation?, Two lateral and two vertical modes may be engaged simultaneously, Only one lateral and one vertical mode may be engaged, with one of each also able to be armed, Only one total FD mode may be either engaged or armed

ATA 22

by
Print
Embed

Leaderboard

Visual style

Options

Switch template

Continue editing: ?