Which of the following is NOT part of the fire triangle?, Heat, Fuel, Oxygen, Carbon Dioxide, During which stage is a fire easiest to extinguish?, Growth, Fully Developed, Ignition, Decay, Flashover occurs during the ________ stage., Incipient, Growth, Fully Developed, Decay, The stage that causes the greatest heat damage is ________., Incipient, Growth, Fully Developed, Decay, The final stage of fire development is ________. It is the phase when the fire decreases in intensity until it is either a smolder or non-existent., Ignition, Flashover, Growth, Decay, Revised Fire Code of the Philippines of 2008 is also known as, RA 9514, RA 9154, RA 9451, RA 9415, RA 9514 repealed ________, otherwise known as the Fire Code of the Philippines of 1977., PD 856, PD 1185, PD 1096, PD 1067, RA 9514 was signed into law on ________., September 19, 2008, October 19, 2008, December 19, 2008, November 19, 2008, Any act that removes or neutralizes a fire hazard, Mitigation, Abatement, Fireproofing, Prevention, An integrated piping system connected to a source of extinguishing agent, Fire Alarm System, Automatic Fire Suppression System, Smoke Control System, Fire Detection System, Any material consisting of a fuel and oxidizer used to produce an explosion, Propellant, Blasting Agent, Pyrotechnic, Explosive Liquid, The temperature at which the vapor pressure of a liquid equals atmospheric pressure, Flash Point, Boiling Point, Fire Point, Ignition Temperature, A highly combustible compound produced by reacting nitric acid with cellulose, PVC, Nitrocellulose, Polyethylene, Polypropylene, A combustible liquid has a flash point at or above ________., 38.7°C, 47.8°C, 37.8°C, 48.7°C, A normally open device installed inside air duct systems which automatically closes to restrict the passage of smoke or fire., Sprinkler, Damper, Valve, Standpipe, A hot glowing piece remaining after partial burning, Spark, Ember, Flame, Ash, Fire is characterized by the ________., Presence of smoke only, Oxidation only, Heat and light of combustion, Presence of fuel only, A fire wall must have a fire resistance rating of at least ________., 1 hour, 2 hours, 3 hours, D. 4 hours, The most common sprinkler system to which when the temperature at the ceiling gets hot enough, the glass bulb or fusible link in a sprinkler breaks., Dry Pipe, Deluge, Preaction, Wet Pipe, The most complicated sprinkler system, where a specific event must happen first before water is released into the system., Wet Pipe, Dry Pipe, Preaction, Deluge, Which sprinkler system uses open sprinklers or nozzles?, Wet Pipe, Dry Pipe, Preaction, Deluge, Foam extinguishers are recommended for ________ fires., Class A, B, C, and D, Class A and B, Class E, Class F, Dry powder extinguishers are suitable for ________., Class A and B, Class E, Class A, B, C, and D, Class F, Wet chemical extinguishers are intended for ________., Class E, Class A, B, C, and D, Class F, Class A and B, Carbon dioxide extinguishers are primarily used for ________., Cooking oil fires, Electrical fires, Wood fires, Magnesium fires, Which extinguisher is best for Class A fires?, Carbon dioxide, Water, Wet Chemical, Halocarbon, Halocarbon extinguishers are ideal for ________., Wood storage, Chemical plants, Server rooms and sensitive electronics, Kitchens, Class A fires involve ________., Flammable liquids, Ordinary combustibles, Electrical equipment, Cooking oils, Class B fires involve ________., Wood, Flammable liquids, Metals, Plastics, Class C fires involve ________,, Cooking oils, Metals, Energized electrical equipment, Rubber, Class D fires involve ________., Wood, Electrical equipment, Combustible metals, Paper, Class K fires involve ________., Plastics, LPG, Electrical panels, Cooking oils and fats, A standpipe system consists primarily of ________., Underground piping, Vertical pipes with hose connections, Fire alarm cables, Smoke ducts, Class I standpipe systems use ________., 38 mm (1½")hose, 64 mm (2½") hose, 25 mm (1") hose, 50 mm (2") hose, Class II standpipe systems use ________., 38 mm (1½") hose, 64 mm (2½") hose, 25 mm (1") hose, 50 mm (2") hose, Class III standpipe systems combine the requirements of ________., Dry and Wet, Class I and Class II, Sprinkler and Standpipe, Manual and Automatic, According to NFPA 14, the maximum travel distance to a hose connection in a sprinklered building is ________., 100 ft, 130 ft, 200 ft, 250 ft, The maximum travel distance in an unsprinklered building is ________., 100 ft, 130 ft, 150 ft, 200 ft

SPDI - Fire

by
Print
Embed

Leaderboard

Visual style

Options

Switch template

Continue editing: ?